Perle Systems Inj 2113-T PoE Injector 60W PoE 1 x RJ45 1 x Push-In XT

Perle Systems 10040668 Specifications

Inj 2113-T PoE Injector 60W PoE 1 x RJ45 1 x Push-In XT

At a Glance

10/100/1000 Mbps Supply PSE power to PoE, PoE+ and Hi-PoE compliant devices Provide 4 to 60 Watts of PoE power IEEE 802.3af, IEEE802.3at and IEEE802.3bt compliant Support for PoE PDs: Class 1 to 6 & Type 1, 2 and 3 Extended supply voltage range of 18 V DC ... 57 V DC, redundant Safe shield connection to ground potential Extended temperature range of -40°C to +75°C Electrical isolation of the internal power supply unit Integrated surge protection to ensure high system availability Wiring space covered with front panel cover

Overview

See all products INJ 2100-T PoE Injectors are DIN Rail mounted single port, PoE mid-span injectors. In environments vulnerable to voltage surges, it acts as an intermediary devices between a non-PoE switch and a PoE device to injectfully compliant power over the Ethernet cable. With electrical isolation of the internal power supply, the INJ-2100-T units are protected against short circuits on the PoE side. The integrated surge protection increases system availability by protecting the connected end devices. Generating up to 60 Watts, the INJ-2100-T provides electrical power to remote PD access points,pan-tilt and zoom (PTZ) cameras and video-phones. It complies with the IEEE802.3bt Hi-PoE (60W of power) or IEEE 802.3at PoE+ (30W of power) standards and is also backward compatible with IEEE802.3af PoE (15.4W of power).Learn more about PoE. With the INJ-2100-T, there is no need to buy an expensive PoE switch or install electrical wiring and outlets in hard to reach locations. Just use and open port on an existing non-PoE switch to save time and money by sending power and data over the same cable.

Certifications & Standards

IEEE 802.3bt IEEE 802.3at IEEE 802.3af EMC Directive 2014/30/EU CE-compliant EN 61000-4-2 EN 61000-4-3 EN 61000-4-4 EN 61000-4-6 IEC 61643-21